I have made lots of Custom Poles over the years. Expect a 2-4 week minimun processing time on custom orders.

Processing time will be dependent on required design time and what types of parts I may have on hand, Material Order lead times, etc.

I don't charge an Arm and Leg for custom work, I really enjoy it, but with multiple requests and other jobs, I do get behind.

Drop me a note about what you are looking for and I can give you a time and cost quote.

Defining what you want is the starting point.

[ john@linghunt.com ] [ 707-477-0869 PST ]

--------------------------------------------------------------------------------------------------------------------------------

 

 

I made these Grip sections for a Diver that has some 30+ foot of Linghunt Polespear. He likes to have many poles setup at the same time with different tips. He likes all of these short Add in grips to compliment his stack of pole sections.

---------------------------------------------------------------------------------------------------------------------------------

 

This Pole Package has 4 sections of 3 foot and a 1 foot front section.

13 foot pole then add tip length. Note a 6th section that is for rear of pole, This diver can then use that for different setups. Lots of misc stuff in this package.

------------------------------------------------------------------------------------------------------------------------------------

 

Below is 5 section pole with a Breakaway Slip tip and Rear sloted butt. Note the 6-8 foot rubber for different power levels for different length set ups.

----------------------------------------------------------------------------------------------------------------------------------

 

The is a stub section no anodized. you can see the straight knurl grip used to snug your pole sections together. I came up with this from some sore hands on doing too many pole assemblies in a Day. with Wet gloves out in water changing your pole around these are a nice feature that is not common place.

Just part of the little things I do to make the Linghunt Polespear the best I can.

-----------------------------------------------------------------------------------------------------------------------------

 

Here is a Slip tip where the Diver can change out the Base for a Fixed Slip tip OR a Full Breakaway.

---------------------------------------------------------------------------------------------------------------------------------

 

Below is a stack of Slip heads. Diver that wanted these has a clip on the Base of the Slip tip [like one above].

He wanted multiple tips so the deck hands in boat could get the fish off his pole fast be just adding a new head.

---------------------------------------------------------------------------------------------------------------------------------

 

Below is a CABLE Stringer. The Green Loop and Black MONO lines goes to the breakaway Slip Head. You unclip the green loop slide the fist into stringer area and re-hook up. This was a set-up for a SCUBA Diver. That's a nylon Tube over the SS cable.

--------------------------------------------------------------------------------------------------------------------------------

 

Below is a protective SS cap that "snaps" on to the head of the tip. A groove and C-clip hold it in place.

I made these for a few divers looking for a "Blunt Force Trama" spear tip. Has been used on Lionfish to knock them out.

 

I did an Axial Knurl on this one. Had this feature on a PowerHEAD to reduce slip on the fish/target. Added Cross hole so It can be put on clip to reduce chance of loss.

-----------------------------------------------------------------------------------------------------------------------------

 

 

Below is a Custom Pole set up that has a secondary Grip for a small woman with limited arm reach. She does two pulls to get it fully loaded.